STU3 Candidate

This page is part of the FHIR Specification (v1.8.0: STU 3 Draft). The current version which supercedes this version is 5.0.0. For a full list of available versions, see the Directory of published versions . Page versions: R5 R4B R4 R3 R2

4.3.1.175 Value Set http://hl7.org/fhir/ValueSet/list-item-flag

This is a value set defined at http://www.nehta.gov.au .

Summary

Defining URL:

http://hl7.org/fhir/ValueSet/list-item-flag

Name:

Patient Medicine Change Types

Definition:

Example Item Flags for the List Resource. In this case, these are the kind of flags that would be used on a medication list at the end of a consultation.

Committee:

FHIR Infrastructure

Work Group

OID:

2.16.840.1.113883.4.642.2.175 (for OID based terminology systems)

Copyright:

Copyright © 2012-2013 National E-Health Transition Authority Ltd : This document contains information which is protected by copyright. All Rights Reserved. No part of this work may be reproduced or used in any form or by any means--graphic, electronic, or mechanical, including photocopying, recording, taping, or information storage and retrieval systems--without the permission of NEHTA. All copies of this document must include the copyright and other information contained on this page. Revision 1 Telephone: 1300 901 001 or email: servicedesk@nehta.gov.au Disclaimer: The National E-Health Transition Authority Ltd (NEHTA) makes the information and other material ('Information') in this document available in good faith but without any representation or warranty as to its accuracy or completeness. NEHTA cannot accept any responsibility for the consequences of any use of the Information. As the Information is of a general nature only, it is up to any person using or relying on the Information to ensure that it is accurate, complete and suitable for the circumstances of its use.

Source Resource

XML / JSON

This value set is used in the following places:

This value set is the designated 'entire code system' value set for Patient Medicine Change Types
List.entry.flag (Example)

4.3.1.175.1 Content Logical Definition

This value set includes codes from the following code systems:

Include all codes defined in urn:oid:1.2.36.1.2001.1001.101.104.16592

4.3.1.175.2 Expansion

This expansion generated 06 Dec 2016

This value set contains 6 concepts

Expansion based on urn:oid:1.2.36.1.2001.1001.101.104.16592 version 1

All codes from system urn:oid:1.2.36.1.2001.1001.101.104.16592

Code	Display	Definition
01	Unchanged	No change has been made to the status of this medicine item.
02	Changed	The medicine item has changed. The change may be described in an extension (not defined yet)
03	Cancelled	The prescription for this medicine item was cancelled by an authorized health care provider. The patient may be advised to complete the course of the prescribed medicine. This advice is a clinical decision made based on assessment of the patient's clinical condition.
04	Prescribed	A new medicine item has been prescribed
05	Ceased	Administration of this medication item that the patient is currently taking is stopped or recommended to be stopped (i.e. instructed to be ceased by a health care provider). This cessation is anticipated to be permanent. The Change Description should describe the reason for cessation. Example uses: the medication in question is considered ineffective or has caused serious adverse effects. This value applies both to the cessation of a medication that is prescribed by another healthcare provider or patient self-administration of OTC medicines.
06	Suspended	Administration of this medication item that the patient is currently taking is on hold, or instructed or recommended by a health care provider to be temporarily stopped, or subject to clinical review (i.e. the stop may be temporary or permanent depending on the outcome of clinical review), or temporarily suspended as a pre-requisite to certain surgical or diagnostic procedures.

See the full registry of value sets defined as part of FHIR.

Explanation of the columns that may appear on this page:

Level

A few code lists that FHIR defines are hierarchical - each code is assigned a level. In this scheme, some codes are under other codes, and imply that the code they are under also applies

Source

The source of the definition of the code (when the value set draws in codes defined elsewhere)

Code

The code (used as the code in the resource instance)

Display

The display (used in the display element of a Coding). If there is no display, implementers should not simply display the code, but map the concept into their application

Definition

An explanation of the meaning of the concept

Comments

Additional notes about how to use the code